How many times have you wished you could get a scope probe to an
unreachable pin, wire a jumper so you can force a pin to a known
state, or connect an LED to a pin to see what it is doing?
J-SCAN lets you view and control JTAG pins in real time
without having to touch your board! With a simple click of your
mouse, you can set pins HIGH or LOW and observe the results right
from your PC screen.
J-SCAN works independently of any logic inside the JTAG
device, you do not need to have any code or firmware installed.
It could not be any easier to program FLASH devices on your
Simply indicate which JTAG pins are connected to your FLASH device,
select your data file and click PROGRAM. That’s all there is to
it! No netlists, no test vectors, no test fixtures or test
See J-SCAN flash programming in action with the latest of our
technical training videos: “Introduction
to JTAG Flash Programming”
J-SCAN is so simple to use you’ll be up and running in
minutes even if you have no previous boundary scan test experience.
View, monitor and control inaccessible solder balls under BGA
Seeing is Believing!
The J-SCAN boundary scan kit comes complete with everything you’ll need
including a Macraigor usbDemon, test and flash programming software,
multi-vendor demo board with 9Vdc power supply, user manual and free software
upgrades for the first year. AVAILABLE FOR WINDOWS BASED PCs ONLY at this
You can purchase the kit without a usbDemon. You
will then be issued a license code to program into your usbDemon to
allow it to work with J-SCAN. AVAILABLE FOR WINDOWS BASED
PCs ONLY at this time.
At a glance:
monitor all boundary pins
change the state of any
no code needed on board
program FLASH devices
no netlists or vectors
can use vendor BSDL files
demo board included
video tutorials available
no experience needed!!
everything included for 1